#: 11617 S1/General Interest
    04-Aug-91  20:32:47
Sb: #Sterm1.5
Fm: Paul Hanke 73467,403
To: anyone

I recently downloaded Sterm.AR, un-arced it and read the manual.   After
setting attributes, creating a SYS directory, etc. I was able to get to the
boot-up screen and test the commands.  But Sterm was stuck at 9600 baud. 
Setting xmode /term=4 type=0    I re-tried but was not able to change the
setting to 2400 baud. What else is necessary to change the baud rate?  Also,
does Sterm work on Multi-Vue as well as from regular OS9?  Couldn't even get to
main menu if I booted from MV.  Can /M1 as well as /T2 be used as a port?
-ph- 

There is 1 Reply.