#: 5089 S3/Languages
    11-Jul-90  18:50:13
Sb: #Basic09
Fm: Floyd Resler 72500,2572
To: all

I have a couple questions about BASIC09.  Does something get messed up when you
use a GOSUB or call another procedure between EXITIF and ENDEXIT?  For example,
   EXITIF variable>2 THEN
   GOSUB 200
   ENDEXIT

   or

   EXITIF variable>2 THEN
   RUN program
   ENDEXIT

  In either of the above examples, control returns after the ENDEXIT not at the
bottom of the loop.  Am I doing something wrong or is this just a problem with
BASIC09?


Question 2: Sometimes, while in the trace mode, I'll hit a STOP in the my
program will end (of course).  However, from that point forward, all results of
variable manipulation are displayed whether I'm in trace or not.  Is there any
way to stop this other than restarting BASIC09?

There is 1 Reply.