#: 18075 S1/General Interest
    12-May-93  04:30:47
Sb: #VPT & Columns
Fm: keith bauer 71102,317
To:  Bob van der Poel 76510,2203 (X)

Bob,

        I need a little help with something. I have a file that I am trying to
print out into 3 columns. The file has about 200 lines in it and each line is
26 characters long. I put the printer in condensed mode and I get thre columns
just fine except that the left column starts one line lower than the center and
right columns. What do I need to set to stop this? The lines in the file are:

co 3 \fc 100044               2.5000 100067               9.0000 104020
5.9000

the file continues like this till the end. I have tried putting
co 1 and the end to balance them out, which is does, but that first line is
still low.

Thanks,

 Keith Bauer

 CIS   :71102,317
 Delphi:keithbauer
 Genie :k.bauer

 Via InfoXpress/OSK ver 1.00


There is 1 Reply.