#: 3405 S7/Telecommunications
    10-May-90  19:53:52
Sb: #3385-#RE 3293
Fm: LUTE MULLENIX 70721,2230
To: Bruce Isted (UG VP) 76625,2273 (X)

Bruce:

The problem is only on start up. If I turn the modem on before the program is
exicuted every thing seems to work fine. At the end of a session the modem can
be shut off and the program will exit correctly. The problem seems to come only
if the program is running when the modem is turned on. (Most of the time, not
always) there has been a few times when every thing has worked OK.

I have switch to using my old Modem I, it seems to be working properly. So I
will stick to using this till I can upgrade to a more suitable unit. I'm using
a Disto controller with a 3in1 board, and the ACIA is a 6551, however in the
manual that comes with the board it says that the DSR and CTS to the ACIA are
always enabled. If this is the case, then I shouldn't have the problem you
mentioned should I?

Bill Dickhaus seems to think the problem lies with the Modemphone. He feels it
must be doing something on startup that something doesn't like.

     >Lute<

There is 1 Reply.