#: 11349 S10/OS9/6809 (CoCo)
    11-Jul-91  23:55:30
Sb: #11313-#Smartwatch
Fm: Paul Rinear 73757,1413
To: Ken St.Clair 71615,267 (X)

     This isn't hard. You unplug the Rom chip inside the disk controller and
then remove its socket. You then solder the smartwatch in its place, plug the
Rom into this, and solder a small jumper wire. If you can solder small IC pins
to printed boards reliably, you can do this.
     Don't make the mistake I made: I soldered the smartwatch in place of the
disk controller chip. It goes under the ROM chip.
                               Paul

There is 1 Reply.