On Mar 27, 1997, Chris Maddock wrote to Hayes Support:
 CM> I noticed with interest that you posted a entended
 CM> command/response for the S95 register.
 CM> Can you post or tell me what are the extended commands (What
 CM> are available?) and the responses please.
See if this does it for you:
 Register S95 (bitmapped)
 Value | Bit          |  Function
 ========================================================================
 1     | 0            |  CONNECT result code (verbose or numeric)
       |              |  indicates the line speed (rather than the
       |              |  DTE speed).
 ========================================================================
 2     | 1            |  Append "/ARQ" to the verbose CONNECT result code
       |              |  if the protocol is not "NONE".  Example:
       |              |  "CONNECT 9600/ARQ".
 ========================================================================
 4     | 2            |  Enable the CARRIER result codes.
 ========================================================================
 8     | 3            |  Enable the PROTOCOL result codes.
 ========================================================================
 16    | 4            |  reserved
 ========================================================================
 32    | 5            |  Enable the COMPRESSION result codes.
 ========================================================================
 64    | 6            |  reserved
 ========================================================================
 128   | 7            |  reserved
 ========================================================================
 256   | 8            |  Enable the MODULATION result codes.
 ========================================================================
 -JrS
  ogre@nashville.com
--- Squish/386 v1.11
---------------