>        I think I have found what you need to change...  Go to Qmodem
  >Setup - CONFIG/DEVICE/Term Cmds and you will see a window which displays
  >all the Terminal Commands etc.  One of them is Connect Msg.  This should
  >contain CONNECT with NO baud rate following it.  The book says if you
  >specify an number and you connect at a different rate, the system won't
  >recognize the Connect.  Check this out....
Hi Charlie,
I'll check that. I think you may have it, a small bell is going off in
the back of my head. What I need to do is check the modem manual and see
what it is looking for, and change the message to that. Thanks again,
and a safe, healthy, prosperous New Year to you and yours.
---
 þ QMPro 1.53 þ Time flies like wind.  Fruit flies like pears.
--- WILDMAIL!/WC v4.12 
---------------