RD>I have an Icon in program mgr in the MS Soulitions group and when I
RD>double click it there it starts but in a window and if I open settings
RD>and set it to full window it runs in a full window but when I close it
RD>and go back I have to do the same thing, in short it will not open in a
RD>full window from the Icon in Prog. Mgr.  It did before and I can't
RD>figure out what or where I am messing up.  Any help would be
RD>appreicated.
        Go into the Windows PIF Editor and select the .PIF file being
used/called when you double click on that Icon.  One of the options
which is displayed by the .pif editor is a box where you can specify
whether you want it in a window or Full Screen.  Change your selection
on that box, save the change and then Double click on the Icon.  Your
problem should be solved....  If I can be of further assistance contact
me at one of my Internet address below.
Charles Raine           Internet: charles.raine@mwcs.mb.ca
Phone: (204) 895-0940             charles_raine@mbnet.mb.ca
--- QScan/PCB v1.17b / 01-0105
---------------