This message was from GWREP CAMI to ALL,
originally in conference comp.os.ge
and was forwarded to you by ANNE PAGE.
                    -------------------------
Message-ID: 
Newsgroups: comp.os.geos
Organization: AOL http://www.aol.com
From the GeoInfoDatabase, your answer is here:
------snip-----
Install: KR-01 Divide by Zero, fast computers
If you get a "KR-01 Divide by zero" error message while installing GEOS on
your Pentium or fast 486 computer, try disabling turbo mode (go down to
25mhz as opposed to 50mhz, for example) while installing. If your computer
doesn't have a turbo button, you might be able to change the speed in the
CMOS setup. The error may occur during the Printer Driver selection part
of the Graphical Setup.
Once GEOS is installed, you can run at the faster speed without a problem.
If that doesn't work, go to the directory where GEOS is installed and use
the DOS editor to edit the GEOS.INI file. Find the line near the beginning
of the file that says:
 continueSetup = true
change it to read:
 continueSetup = false
Then save the file, exit the editor, and run GEOS normally (run GEOS by
typing GEOS, KERNEL, GEOS20, or LOADER, as appropriate. Do not run SETUP
again, or it will change your "false" back to "true").
Article#0527
Updated 05/29/96
Transmitted:  96-06-08 15:05:09 EDT
-------snip-----------
 * SLMR 2.1a * You're welcome to my advice; I don't need it for myself.
--- QScan/PCB v1.16b / 01-0075
---------------