On , you wrote:
 FB> Check to make sure that your modem is set up properly to maintain
 FB> the DTE rate regardless of the modem-to-modem rate.  In USR modems,
 FB> for example, the setting is &B1.  The setting &B0 will cause the
 FB> modem to change the DTE rate to the modem connection rate, which
 FB> will cause the problem you described.
  Yes Fred, I checked my modem (not a USR, unfortunately), and found the
  equivalent settings. I also asked a local Commo expert here, and told me
  to _turn-off_ the auto-baud feature (did I tell you I'm only using Commo
  6.00 ?). It worked like magic. He told me that the later versions
  starting from Commo 6 don't have the auto-baud feature setting anymore.
  Thanks again, your recommendations were very much appreciated. BTW, I'll
  be checking out your newer versions, because these friend whom I asked
  for help is using a Commo 6.5! (latest, according to him)
--- Blue Wave/Max v2.20 [NR]
Hi Jim,
 JB> I'd be glad to.  Do you have an internet E-Mail address I could send
 JB> it to?  I don't know if an UUENCODED file would go over very well in
 JB> this conf.
     sorry... i just got virus and deleted my whole point setup in a BBS 8(
     can you try sending it here... via UUENCODE, hope it get thru!
Regards, Sherwin Lim
--- Maximus 3.00
---------------