JH> Thanks...thought of the swtich box being bad, changed it out no luck.  I
JH> did the "System printer" trick and played with some other settings...now
JH> I am getting an Error 20 on the printer..out of memory...just my
JH> luck...we are going to try swaping the printer to an HP 4+ with 32megs of
JH> RAM...hope it works.
That should do it Jim! Or you can set the "SWAP FILE" size a little larger in 
Windows. I was just reading where they recommended a 4.5 MEG size, swap file 
for larger AUTOCAD size prints. This should solve that problem.
Good Luck
... And now, some words of wisdom:
RAM DISK is NOT an installation procedure!
--- GEcho 1.00
---------------