Check your
CR>documentation that came with your computer and select the Specific Modem
CR>that is in your Computer.  I doubt if you have a Generic 2400 baud modem
CR>in your 486...  If that is in fact what you have, I'm not surprised that
CR>it doesn't support FAX....  Get a faster, more sophisticated modem if
CR>you want to use it for FAX...
Thanks for your reply; Maybe Santa will remember me and do something
about that new modem. I got into the OPTIONS/DEVISES area and tried
everything that looked remotely like it might work, even a couple of the
Packard Bell ones. The P B manual was no help in this case. Then going
on over to the Trouble shooting guide area in the Qmodem manual, I tried
setting baud rate to 19200 and at least the modem initializes, and goes
into wait. I have been busy, so have not done much with it since.
---
 * OLXWin 1.00a * Press "+" to see another tagline.
--- QScan/PCB v1.17b / 01-0406
---------------