Hi Chris,


 >BT> to all the ppl out there, i have an ELLCON V.34,   28.800  modem and
 >BT> are have terabile trouble getting it to run a fax prog.all i get, when
 >BT> i try to send a fax is no dial tone.this occurs in both Dos and through
 >BT> W/95. i think it might be my setup string.
 > 
 > That modem is particularly bad at recognising the Australian dial 
 > tone, so you need to add X3 to your dial string so that it blind dials. 
 > There's usually a sheet of paper in the box with the modem which mentions 
 > this. Change your dial string to ATX3DT or make X3 part of the init 
 > string.

This message came to me (Bill Thompson) on the Common Ground BBS.  There
must be another Bill Thompson (the author of the original message your
reply was meant for) at another address.   This has happened once before,
and I reported it to CG, but obviously messages are still getting
misdirected to me (and perhaps my messages to him!!).

Suggest you re-send and hope it gets to the right person.

Regards, Bill T,  (Common Ground)


--- TMail v1.31.5