#HB#> Next, load up Telix. Make sure it's set for the correct comm
 #HB#> port/addr/irq. It should then work.
 DG> /Should/ is the operative word. Telix hangs each time I try
 DG> to switch it to COM4. So far I've tried a variety of port
 DG> addresses/IRQs, each with no more success than the other.
   Telix assumes the port hw (real or virtual) is in a certain state, and 
usually hangs if its not as expected.  Start Telix from a batch file so you 
can use MODE to set up the port first:
   Mode Com2,9600,N,8,1,OCTS=Off,RTS=Off,ODSR=Off,IDSR=Off,Buffer=On
Jeff
--- timEd/2 1.01
---------------