*** Quoting Donald Quarles to T Owen dated 04-07-96 ***
> 
> we there are no preamps just a stright amp. I do not use phantom
> power,But yes it is working. but there is one thing i found out
> about this system they hooked up the processer to the 16th
> channel and you can control the amount of reverb from the 16th
> channel. Myself I don't understand why because the mixing board
> has a knob for the amount of reverb..
> 
> Donald Quarles A.K.A BAD
> 
A simple explanation would be is ..... that by using a channel as a return 
you can equalize the effect ...  this gives me another place to look for the 
source of your noise problem ... try turning up the input on the 
reverb/delay/processor while the system in being used so the red light on the 
processor level led just barely clicks on.. then turn down the output of the 
processor and see if the noise goes away ...  channel 16 trim should be set 
at about 12 o'clock .. staight up ... the concept here is to drive the 
processor input to it's max without overdriving it and turn down the output 
of the processor so you don't amplify it's inherent noise ... get it?
--- T.A.G. 2.7c Standard
---------------