Can anyone help?
I have Telix 3.22 running with a Netcomm SmartModem V.32 E5
Unfortunately the Telix program did not have my modem listed so I've setup on
the one that seem to run the best. It works fine but there are a few minor
things that I would like cleared up if possible.  
I am running at 9600bps with no problems, (connections, download, upload and
chat).
The status bar in Telix reads 19200 when I start the program and initalize 
he
modem. The connection box when you have dialed and connected has a blank
connection speed and then the status bar says that I've connected at 1200bps
when I,'ve actually connected at 9600bps.
I have to manually type in ATZ to reset the modem after I have
disconnected or hang up. (No real hassle) 
Apart from the above as I have said it runs fine but I would like to see if
anything can be done to correct it, any help would be appreciated. 
Thanks Jan.
--- Blue Wave/DOS v2.21 [NR]
---------------