[ Quoting Peter Lane-Collett to Mark Shole ] 

 MS> run ANY comms software under Win95 (even the freebie one that comes with 
 MS> it) I have to set the baud rate to 19200 or even 9600. I have a 28.8 modem 
 MS> (Banksia) and Win95 is supposed to support it... I have the same problem 
 MS> with Dial-up Networking to call my ISP. 9600 baud again...

Go into the control panel -> system -> device manager

Find the branch with PORTS on it. Make sure everything in there is set up
properly (hardware flow control, 38400 or higher BPS

Also, find the modem branch (if there is one) and do the same.

Back in the control panel, find the Modems icons, and check the properties
of you modem in there.


Regards,
 - SoNiC 

[ Scott Little (SoNiC) admin{at}cyberia.asstdc.com.au ]

--- FMail/Win32 1.22