On Fri 11 Oct at 19:33 craig{at}dyson.brisnet.org.au (3:690/660.1000{at}fidonet)
wrote to All:

 c> From: craig{at}dyson.brisnet.org.au

 c> I'm having problems connecting a Motorola Lifestyle 28.8 to 
 c> the Maestro V34 (V34+).  The connects are fine at 28.8 
 c> V34 but for some reason I can't get V43bis and it isn't 
 c> negotiating MNP either.

 c> I have \N7 set for LAPM & MNP error correction and I've 
 c> turned off the V43bis fast train setting.

 c> Any guru's out there that can help......even what the 
 c> setting is to turn of LAPM and try MNP only would help.

 c> Regards

 c> Craig 
 c> craig{at}dyson.brisnet.org.au
 c> Brisbane, Queensland, Australia.
 c> http://dyson.brisnet.org.au/~craig

Use the AT$H command to display the online help and perhaps use the
following settings:

&R        CTS normal operating state

&S1       DSR on when ready to accept data

%R2       Enable auto rate adaption, medium BER

\Q3       Enable bilateral CTS/RTS flow control
\X1       Pass XON/XOFF characters to remote DCE

*TH1      Medium V.34 rate selection threshold

ACTIVE PROFILE:                                      DTE =  38400 BPS  8/NONE/1
E0 H2 L2 M0 Q0 V0 X4 Y1 &C1 &D2 &G0 &L0 &M0 &P0
&R0 &S0 &T4 &X0 %A0   %B16  %C1
%D0   %L1  %R2 \A3 \B35  \C0 \G0 \J0 \K5 \M1 \N7 \Q3 \R1 \T0   \V4 \X1 *AS1    
*DG0 *DN0 *DR0 *FT0 *ID0 *MM0  *OR0 *RA0 *TD18 *TH1 *TL21                      
S00:002 S02:255 S03:013 S04:010 S05:008 S06:004 S07:030 S08:004 S11:080 S12:050
S18:000 S25:005 S26:000 S41:061 S42:050 S73:000 S74:015 S75:000 S76:015 S77:000

Motorola Lifestyle 28.8 External 68356 ROM  SW REV 2
S209415900 -01 08/03/95    8:00am

--- msgedsq 2.1