KA>I have covered these tracks so far, with no success:
KA> Checked the modem setup string, and ATE1 is in there.
KA> Terminal emulation is ANSI.
KA> Set to Full Duplex.
KA>Yet, when I type a command, nada!
KA>Any ideas as to what else can cause this error?
KA>Thanks for any help.
If, when you're in terminal mode, and you enter AT, and you don't
get a response, then the computer is not communicating with the modem.
(regardless of the ECHO setting)  Double check the Comm address and
interrupt.  If you're running it through Windows, you'll have to be sure
there is no irq (interrupt) conflict.
--- Olms 2.0 [PKMAI4AP]
---------------