*Quoting you to Rick Collins*
 RC>bs> I should mention that I tried all three programs with all
 RC>bs> combinations of "\J1", "S95=1,45,47" etc.  At no time was S95
 RC>bs> ever able to override the "W" setting and produce a DCE value.
 RC> Post _all_ the strings you're using (pre init, init, dial,
 RC> whatever) and label them as to what they are.  This is suspicious.
BS>* --------------- Here is a screen dump from Terminate ---------------*
BS>ATZ
  >OK
  >at&v
BS>ACTIVE PROFILE:
  >B1 E1 L2 M0 N1 T Q0 V1 W0 X4 Y0 &C1 &D2 &G0 &J0 &P0 &Q0 &S0 &U0 &Y0
  >%A013 %C1 %E1 %G1 \A3 \C0 \G0 \J0 \K5 \N3 \Q3 \T000 \X0 -C0 -J1 "H3 "O032
  >S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:050 S08:002
  >S09:006 S10:014 S11:070 S12:050 S18:000 S25:005 S30:000 S33:000 S37:000
               ----------- snipped -----------
BS>Everything above is factory default except for "M0" ... turned it off
  >because of tinny noise from speaker :-(
Nothing wrong with those settings. Odd however that you say that use of
the S95 register doesn't correctly reflect DCE speed. The AT&T chipset
used in the Logicode fully supports S95 use. In any event the W2 setting
will do for DCE reporting. S95 merely expands the reported facilities.
Reading your prior post where you say that CONNECT 31200 is reported by
the modem which however then in Telix changes to 1200 almost sounds as
though Telix ( being somewhat old and prior to 28/8/33.6 speeds ) does
not recognise the 31200 as valid and reverts to 1200. And possibly also
the same applies to Terminate ( incidentally not a program on my hit
list).
Try forcing a lower speed connect via S37 register , say down to
14400 which Telix will certainly recognise .. S37=11 probably ... and
see if matters proceed OK. Also use W2 and S95=0. If all OK  then the
software is at fault.
BS>The rest of the info you asked for is as follows:
BS>pre-init string ........ none
  >init string ............ ATZ^M
  >Dial prefix ............ ATDT
  >Dial suffix ............ ^M
  >Lock Port .............. yes
  >Xon/Xoff ............... off
  >CTS/RTS ................ on
  >DSR/DTR ................ off
  >FIFO buffer size ....... 14
  >Terminal ............... Avatar/ANSI
BS>These are the settings for Terminate ver 4.00 but everything is
  >identical to the above when I have used Telix 3.21 & 3.51.  I have
  >also tried TTY and ANSI/BBS with no effect.
Nothing much wrong with these either. One item which however has no
bearing on your problem is the FIFO buffer size setting. 8 would be
preferable to guard against data overruns .. 14 leaves only 2 bytes of
headroom and thus marginal. However if you have no problems then leave
as is.
Regards
Don
---
 þ SPEED 1.30 [NR] þ Don Black - Durban - South Africa. don.black@als.co.za
---------------