Message-ID: 
Newsgroups: AIRGUN.LIST
>  Phil,
>  Dean S. had originally wanted to remove a dent in the pump tube as I
> recall,
>  not the barrel! ( same procedure with barrel dent of course, just have
> to hit
>  the bearing ALOT harder!! :)
>  Rob P.
Whoops! Whole different deal. Just to fill those people in who might be
curious, If you take a hardened steel pin .250" in dia. and drill a hole in
mild steel the same dia. the pin should slide in the hole with some slight
resistance. Make the hole .249 (.001) smaller and you can with some effert
drive the pin in the mild steel. Lots of luck getting it back out. Make a
hole .248 dia. in the steel and in won't go in with a multi ton arbor
press. 
 By the way,is anyone out there going to Hermando for the National FT
Championship at the end of May?
Phil.P.
--- QScan/PCB v1.19b / 01-0671
---------------