From: "Fisher, Nick" 
To: "'atm{at}shore.net'" 
Reply-To: "Fisher, Nick" 


If you do try this method remember to screen the nickels/washers for
thickness: pick two with the same thickness and place them 2 inches apart
on a flat table top and place the blade of a metal ruler or other straight
edge on top, then slide the others underneath the ruler to check that they
are the same thickness, you may find a few that are different: thinner
isn't too bad as at worst they just won't make contact but ones that are
noticeably thicker shouldn't be used. I found that a precurved washer tool
was fine for rough grinding so long as you don't go centre over centre.

Nick


______________________________________________________________________

IMPORTANT: This e-mail, including any attachments, may contain personal,
confidential or privileged information. If you are not the intended
recipient, or if you have received this e-mail in error, please contact the
sender immediately and delete all copies of this e-mail and attachments. If
you are not the intended recipient, you must not use, reproduce,
disseminate or disclose any part of this e-mail or attachments.
______________________________________________________________________

--- BBBS/NT v4.01 Flag-4