To: J Killea 
Cc: atm{at}shore.net, owner-atm{at}shore.net
From: Hugues.Laroche{at}ses-astra.com
Reply-To: Hugues.Laroche{at}ses-astra.com




Hello

>After much time and consternation at 120 grit,
>with a persistent out-of-contact edge,

>I have found that my tool has three tiles that are just too
>high.

Cannot access the web site you mention.

>1)  Pour a new, full diameter Hydrostone

No except if nothing else works.

>2)  Grind the proud tiles down a bit.  I would probably overdo the
grinding

This is one possibility. 3 holes are better than 3 high tiles.

>3)  Go back to #80 and grind 1/3 COC until everything is in better
contact.

As you say your tool is sparsely populated this would be my preferred
solution. With SiC # 80 the 3 tiles will not stay proud for long. If your
tiles are really high, you can slightly apply solution 2 to gain time, w/o
overdoing it.


Happy grinding,

Hugues
Luxembourg, Europe




--
DISCLAIMER:
This e-mail contains proprietary information some or all of which may be
legally privileged. It is for the intended recipient only. If an addressing
or transmission error has misdirected this e-mail, please notify the author
by replying to this e-mail. If you are not the intended recipient you must
not use, disclose, distribute, copy, print, or rely on this e-mail.

--- BBBS/NT v4.01 Flag-4