Message-ID: 
Newsgroups: AIRGUN.LIST
Organization: Mac-1 
Larry Durham wrote:
> 
> In the course of playing with and tuning the Tau 200 rifles, I have
> come
> across some quirks
> that I will share with you.
> 
> The above mods all pertain to my PC conversion, using "hydro-tested
> components" and no more than 2250psi.  If you need help with any of
> the work, or further explanations, email me at:  lhdurham@mindpsring.com
> 
> ld
Since it turns out that this is not the drop in that we originally had
thought it would be. If anyone has a problem with any of the systems
that have already been shipped they can send in the gun and we can tune
it for them. Probably be around $30 labor and we see some guns with a
lot of potential and some guns that don't so the performance that you
want might come easy and in some cases it comes real hard. So service on
these will have to vary somewhat. But the gun needs the valve spring,
valve body mod and spring preload adjust and/or spring replacement. 
We have stock on systems ready to ship but as described if you haven't
got the ability don't buy the kit. We are going to change this from a 3
to a 5/10 on the difficulty scale. Sorry if we got anyone over thier
head. If it goes in noproblem. I'll send four washers out with each kit
and we found if you put the preload washers in front of the spring it
adds hammer weight and often the factory spring will work with 1-4
washers. The problem as ld stated is we find a variety of set-ups on
these guns like they were set at different power levels and porting
levels from the factory. So we don't know yet what to expect. No
patterns are developing that I can detect. Time will tell. Anyway if
their are anymore out there that want the conversion now is the time
cause they are in stock and ready to ship.
Thanks to ld
Tim
-- 
MAC-1 Airgun Distr./McMurray & Son   Phone 310-327-3581 FAX 310-327-0238
http://www.mindspring.com/~airguns/  Hours-M,Tu,F,Sa 11:00AM-6:00PM PST
13974 Van Ness Ave.                  Tim McMurray
Gardena, CA 90249 USA                mac1@concentric.net
--- QScan/PCB v1.19b / 01-0671
---------------