::>  #HB#> You might also want to capitalize the Internet and None.
::> Case sensitive? It doesn't seem so. As I just wrote to Paul W., HA Lite 
a
::> find the virtual port with Internet/None as I originally wrote them.
I don't think it's case-sensitive, but never hurts :)
::>  #HB#> Next, before starting Telix, you need to run the VMODEM.EXE 
rogram
::> Yep. I'm past this stage. :)
Never hurts to double-check :)
::>  #HB#> Next, load up Telix. Make sure it's set for the correct comm
::>  #HB#> port/addr/irq. It should then work.
::> /Should/ is the operative word. Telix hangs each time I try to switch it 

::> COM4. So far I've tried a variety of port addresses/IRQs, each with no 
or
::> success than the other.
Hmm, "sounds" like a setting problem with Telix then. (Which version BTW?)
I've been using 3.22 with VModem for over a year without a problem (Also have 
used Robocomm with good results as well). 
Did you set up a program object for telix? Have the SIO_Allow_Access_Com4
and SIO_Share_Access_with_OS/2 and SIO_Virtualize_COM_ports set to ON in the 
objects Dos Settings? 
I have a separate AUTOEXEC for it, to set the path and TELIX enviromental 
variable (you probably allready checked all these, never hurts to check).
I don't know if it will help, but heres the Terminal options and
Comm port Setup screens from my Telix...
A - Port COM4   Baud 57600    Parity None   Data bits 8   Stop bits 1
B - Emulate before translate table... Off
C - Default terminal type ........... ANSI
D - Status line ..................... Bottom
E - Local echo ...................... Off
F - Add Line Feeds after CRs ........ Off
G - Strip high bit (incoming data) .. Off
H - Received Backspace destructive .. On
I - Backspace key sends ............. BS
J - XON/XOFF software flow control .. Off
K - CTS/RTS hardware flow control ... On
L - DSR/DTR hardware flow control ... Off
M - Compuserve Quick B transfers .... Off
N - Zmodem auto-downloads ........... On
O - Drop CTS during disk writes...... Off
P - Answerback string (ENQ) .........
              Start     IRQ
             Address    Line
 A: COM1 ..... 3f8       4
 B: COM2 ..... 2f8       3
 C: COM3 ..... 3e8       4
 D: COM4 ..... 2e8       3

#  Herbert Bushong    harchon@centuryinter.net       [TEAM OS/2]    
-  Blackbeard's BBS   Intelec: 239:600/0            
+  Fido: 1:19/19      http://www.win.net/eunicecity/stltcc/hbush/
---
   RM 1.31 2508   Rumor: NT means Not Tested
---------------