-=> Quoting Jean Parrot to Bruce Clark <=-

 JP> I have a shortcut to load BW but if I use it then the BWREPFIX
 JP> does not work. If I go directly into the folder and 2-click on the
 JP> BW.exe, all runs fine. Yes, the shortcut point to the right path.

Make sure the shortcut is configured to run in the Blue Wave folder. 

I would have similar problems with Win 3.11 if the PIF file weren't 
configured with a "Start-up Directory" 

Make sure there is an entire path listed to the BWPACK.BAT file. 

Edit the file, so that each command line used has an entire path 
listed: 

{at}ECHO OFF
GOTO %1
ECHO.
ECHO The parameter "%1"
ECHO was not recognized.  Valid values are:
ECHO ZIP, OLDZIP, ARJ, LHA, PAK, ARC, and AUX.
ECHO Please re-check the BWREPFIX.DOC file and your Blue Wave Archiver
ECHO configuration, and make sure your archivers are configured correctly.
ECHO.
PAUSE
GOTO END
:ZIP
C:\BWAVE\BWREPFIX.EXE %3
C:\BWAVE\PKZIP -ex %2 %3
GOTO END
:OLDZIP
C:\BWAVE\BWREPFIX.EXE %3
C:\BWAVE\PKZIP.EXE -e0 %2 %3
GOTO END
-- SNIP --
:END


 
___ Blue Wave/386 v2.30
--- Platinum Xpress/Win/WINServer v3.0pr5a