LS>When we try to boot, it goes through the RAM test, brings up the 
opyright,
LS>buzzes both floppies (5 1/4 and 3 1/2) then places the number 1701 under
LS>the RAM test and locks. I would appreciate info on what this code is.
Lee, I had this problem a number of years ago and below is a message
I received in response to my question. As I recall the solution to my
problem was a loose cable.
Originaly posted by Gordon James of Nova Scotia, Canada
---------
1701 is drive not ready (recognized)
17   Drive error
  0  Not found
   1 Drive 1 (C:)
   There are at least three possible problems.
   1. Cables not hooked up right.
      Make sure Pin 1 on the drive goes to pin 1 on the controller
      (usually signified by a red marking on the ribbon connector)
   2.  No power to drive (Check that it is plugged in)
   3.  Jumpers set wrong on drive.
       Don't play with these until all else fails.
       Then post more info on the drive.
   4.  CMOS type set wrong
   5.  NO Low Level Format
   Try to get a hold of Disk Manager to fix #4 and #5
----------
   
Hope this helps
 * KingQWK 1.05 # 162 * 
(1:119/500)
---------------