MG>1: Say I call one BBS, and it's busy, I hit escape and dial another
MG>one right away, it takes approx 5 seconds before it'll start dialing
MG>again.. (This is not a prob with my software.. It already starts
MG>counting the dialing time and has issued the ATDT command when it's
MG>paused)
MG>Is there a way to make it so it'll start re dialing right away like
MG>my USR 14.4 did??
        Technically in North America, that forced minimum delay
        between calls is supposed to be there.  
        
MG>2: The CONNECT XXXXX (like connect 26400) on my end is often not the
MG>same as the remote side.. Like my end will say I connected at 24000
MG>and the other will say 26400..
MG>Is there any way to fix this?
        Its not "broken", so you can't fix it. :-)
        In V.34 mode the modems have the ability to use different
        carrier rates in each direction...rather than using the 
        best carrier rate the lower quality signal path can support.
        If you really want to disable this you can by setting
        S210=5 
CMPQwk1.42 331ūStart init. strings with AT&Fn for solid configurations
--- FLAME v1.1
---------------