On 20.09.97 Bill Tracy wrote the following to All
in TELIX:
BT> Greetings:
BT>         I have just installed TFW115D.ZIP on to my Lap Top. The
BT> install went O:K. This same computer has TELIX 3.22 on it which
BT> I am using now. Everything is fine. The only thing is that the
BT> TFW will not work. It states that the CTS is low and asks me to
BT> connect my modem. I did chose the correct one when I installed
BT> this fine program. I have a registered version of TFW 1.1 which
BT> is running fine on another computer. I copied the TFW.CGF file
BT> to the new computer install and I did notice 1 change but still
BT> the program does not connect. AT does not say OK and ATDT does
BT> not make a dial tone.
BT>         What files should I copy from the working TFW to the non
BT> working computer to get them both working?
BT>         Any help will be appreciated.
Bill,
provided you're using it, you should be aware, that the TELIX environment
setting points to your Telix for Windows directory. Take a look at your
AUTOEXEC.BAT file for verifying the value of the TELIX setting or simply
run the "set" command at the DOS prompt. Change it if necessary!
However, if you later want to continue in using TFD v3.22 you should reset
this setting (let it then point to your Telix for DOS directory) before,
otherwise TFD v3.22 might fail.
greetings from Germany,
Bernd/2
--- CrossPoint v3.11 R
---------------