From: "Joe Roth" 
Subject: [drakelist] R4C xtal bank bad


"Joe Roth"  made an utterence to the drakelist gang
----------------------------------------------------------------------
I've added a lot of xtals to my R4C. I began to use position 11 which is now 
in the 3 (bottom most) row. The entire row for positions 11-15 will not 
work. The receiver acts as if the xtal sockets are empty. The xtal works 
fine in other positions. I've swapped all combinations around and I know 
there is a problem with the row. I looked at the obvious solder joints on 
the switch and traced the connections of 3 wires going to the underside of 
the chassis. Everything appears to be okay.
I now need to get in to it deeper and trace some lines with the VOM. Does 
anyone have suggestions to narrow things down?
TNX
Joe/N4ARI
www.n4ari.net


----------------------------------------------------------------------
On Behalf of "Joe Roth" 
Submissions:        drakelist{at}www.zerobeat.net
Unsubscribe:        majordomo{at}www.zerobeat.net - unsubscribe drakelist in body
Hopelessly Lost:    majordomo{at}www.zerobeat.net - help in body of message
Zerobeat Web Page:  http://www.zerobeat.net
Brought to you courtesy of TLCHost.net  http://www.tlchost.net/
----------------------------------------------------------------------

---