From: "Don and Diana Cunningham" 
Subject: [drakelist] TR5


"Don and Diana Cunningham"  made an
utterence to the drakelist gang
----------------------------------------------------------------------
Hi all,
I am finally getting serious about re-working my TR5, s/n 01336, and find 
that the aluminum extrusion that makes up the front has some serious dings 
in what looks like the "trim ring" across the top when all is
assembled.  I 
hope I didn't add any of these in my move, and three year storage, but 
nonetheless, they are there.  I may try to "sand" them out with some very 
fine grit paper, but when taking it off, it looked very much like the 
extrusion on the TR7!  Comparing the two bears that out, with one additional 
hole drilled and a couple of the "slots" for controls and the readout have 
been milled out some more.  Does anyone know if this was a special 
extrusion, or if Drake merely milled out those extra slots on a TR7 
extrusion?  Maybe I can locate a "mint" TR7 one and get someone to mill it 
out for me!!  Tks for any help anyone can provide.  Mike, weigh in if you 
remember please.  Your work may have been all design, but maybe you remember 
this one mechanical part, hi.
73 and thanks,
Don, WB5HAK 

----------------------------------------------------------------------
On Behalf of "Don and Diana Cunningham" 
Submissions:        drakelist{at}www.zerobeat.net
Unsubscribe:        majordomo{at}www.zerobeat.net - unsubscribe drakelist in body
Hopelessly Lost:    majordomo{at}www.zerobeat.net - help in body of message
Zerobeat Web Page:  http://www.zerobeat.net
Brought to you courtesy of TLCHost.net  http://www.tlchost.net/
----------------------------------------------------------------------

---