-=> On 05-07-05  09:21,  Jean Parrot <=-
 -=> spoke to Dale Shipp about c:\BWAVE <=-

 DS> To toggle from full screen to window, try using ALT-Enter.

 JP> That did it, Dale. I am in windows and do not see that
 JP> border. If I go to Alt-Space, I get the menu but if I do the
 JP> Alt-enter, I get the fullscreen and that is a misnomer. I run in
 JP> 1024 x 768 and that full screen is a little pane ( paine ? ) I

   I am confused.   Full screen is the entire screen, not a little pane.
   The panes are windows.

 JP> do not think that I would use it. It is about 1/5 of the normal
 JP> screen size. But I will read your saved post over again to see

   If the window is too small, you can adjust it.  Right click on the
   bar at the top.  This time, instead of selecting "edit" select
   "properties".   When you do, a properties sheet opens up.  In that
   properties sheet, there is a tab labeled "font".  Click on it and
   select a font size.   I use size 24 TT Lucida Console.  A bigger
   number makes the window larger, a smaller number makes it smaller.

   While you are there, you might look at some of the other properties
   that you can modify.

   When you are done, you can click on OK and either change the current
   window only, or change the properties for all other windows you open
   with the same name in the future.

 JP> what I can now make of it. I still have not found the keystrokes
 JP> to get back to my full-sized Windows screen. I have to shut down
 JP> BW and retart it from the shortcut bar.

   Full screen means "nothing but BlueWave on the screen, no windows".
   ALT-ENTER toggles back and forth between a window and full screen,
   i.e. hit it once to get a window, hit it again to get back to full
   screen.

                               Dale Shipp
                  fido_261_1466 (at) comcast (dot) net
                              (1:261/1466)


... Shipwrecked on Hesperus in Columbia, Maryland. 23:22:12, 07 May 2004
___ Blue Wave/DOS v2.30

--- Maximus/NT 3.01