Message-ID: 
Newsgroups: AIRGUN.LIST
Thanks for sharing that.  ld
-----------------------
Phil Paskos wrote:
> Whoops! Whole different deal. Just to fill those people in who might be
> curious, If you take a hardened steel pin .250" in dia. and drill a hole in
> mild steel the same dia. the pin should slide in the hole with some slight
> resistance. Make the hole .249 (.001) smaller and you can with some effert
> drive the pin in the mild steel. Lots of luck getting it back out. Make a
> hole .248 dia. in the steel and in won't go in with a multi ton arbor
> press.
--- QScan/PCB v1.19b / 01-0671
---------------