On Wednesday, November 11, 2015 at 7:20:13 PM UTC-8, Charles Gutman wrote:
> Does anyone know where I can locate a CMD RAMLINK Battery and charge cable?
>  I finally got my Ramlink and desire to "pimp it out."
>
>  Thanks in advance,
>
>  Charles


Hi Charles:

Found this post from Maurice and he should know.
I recently had to replace mine.
Often you can get good prices for these batteries at auto supply shops...
e.g. "Trailer/RV batteries".
---

This is for the V2 RAMLink. It's 9VDC at 1amp. It uses a 2.5mm
plug with positive on the center terminal.



6V sealed lead-acid type, preferably 6-7 amp or higher. 4 amp
is OK but won't hold up as long during a longer power outage.
The charging circuit is very slow and takes a couple of days
to bring a low battery up to a full charge. Always leave the
RAMLink powered by its power supply so the battery is always
at a full charge. A fully charged battery will gradually charge
up and show about 6.6 volts while powered up.

-Maurice

--- SoupGate-Win32 v1.05