LO>I have a phone service that I call, I must call this number, than add a
LO>code then the phone number.  now how can I do this with my QmPro?  I
LO>tried doing it using the prefixes as the book says using `(l)  l
LO>is for the letter of the prefix before the number but evidently I did
LO>something wrong. It does not work.
The back-quote tells QmPro to use the prefix as part of the modem
command (to send special AT commands). Try it without the quote. This
will become part of the phone number to dial.
 * QMPro 1.53 * I'll take "General Protection Faults" for $200, Alex.
--- QScan/PCB v1.17b / 01-0128
---------------