|------------------|Leah Owens wrote:
LO>I have a phone service that I call, I must call this number, than add a
LO>code then the phone number.  now how can I do this with my QmPro?  I
LO>tried doing it using the prefixes as the book says using `(l)  l
LO>is for the letter of the prefix before the number but evidently I did
LO>something wrong. It does not work.
 |------------------|about
It's easy...  Go into -Z (settings) select Config...Device...
Prefixes...
Enter the LD Co # or your Phone Credit Card #/codes in entry "A" (i.e.
1-800-933-8000, 4747 (that's some sort of code from the phone
carrier)...
Phonebook...set up the entry (i.e. Pam's BBS, E1-916-673-4269, in CA).
Now when you select Pam's BBS QMP will dial the LD card numbers followed
by the phone # of the BBS.  You can also set up the prefixes to be used
after dialing the phone # (i.e. 1-916-673-4269,B).
Hope you can figure out what I said...just try following my keywords
using your mouse.  After the first time, it's easy.  
Good Luck
áill
... Error 00 : Call customer service for a laugh
---
 * QMPro 1.5+Tag-X Pro v1.20 * 
---------------