On Wed 19 Nov at 17:37 Simon Stone (2:440/624) wrote to Craig Johnstone:
 SS> Ok I changed you NET.CFG file so it said
 SS> === Cut ===[ net.cfg ]===
 SS> Link Driver LSL
 SS>    Frame Ethernet_802.3
 SS>    Frame Ethernet_II
 SS>    Frame Ethernet_802.2
 SS>    Frame Ethernet_SNAP
 SS>         INT 5
 SS>         PORT 320
 SS> # FRAME ETHERNET_802.3
 SS> NetWare DOS Requester
 SS>         FIRST NETWORK DRIVE = G
 SS>  NETWARE PROTOCOL = NDS BIND
 SS> Protocol IPX
 SS>  IPX SOCKETS 40
 SS> #END NET.CFG
 SS> === Cut ===[ END OF net.cfg ]===
 SS> The network card is on Interupt 5, however whe I load 
 SS> NE2000.COM it says the following..
 SS> === Cut ===[ run.txt ]===
 SS> Novell NE2000 Ethernet MLID  v1.54 (931123)
 SS> (C) Copyright 1991 - 1993 Novell, Inc.  All Rights Reserved.
 SS> Int 15, Port 300, Mem D0000,
 SS> Max Frame 1514 bytes, Line Speed 10 Mbps
 SS> Board 1, Frame ETHERNET_802.2, LSB Mode
 SS> NE2000-DOS-54: The board did not respond to the 
 SS> initialization command.
 SS> NE2000-DOS-6: The adapter did not initialize.  NE2000 did 
 SS> not load.
 SS> === Cut ===[ END OF run.txt ]===
 SS> All I can say is ARRGG, please help me...
 SS> Please reply asap, I know a lot about PC's but practically 
 SS> nothing about Netowrk settings, I know plenty about networks 
 SS> though :)
You need the setup program or jumper settings for you card right, then edit 
NET.CFC as appropriate.
INT 5, I/O address 300h should be fine for single printer clients with 
nothing else conflicting.
--- msgedsq 2.1
---------------