Hi Greg Mayman!
28-Aug-96 06:13:49, Greg Mayman tapped feverishly away and wrote to All
 Subject: Label Printing
 GM> I've asked this one before, and the answers I have been given
 GM> dont work!!!
 GM> What I want to do is to print some labels, all the same, on 3-1/2
 GM> inch wide by 1 inch high address labels which come in a strip on
 GM> a backing with sprocket holes for the printer. OK so far?
 GM> THE PROBLEM: To print on 3.5 x 1 inch strip labels.
 GM> What is the answer? Can GeoWrite be made to work with zero
 GM> margins? Can GeoDraw be made to print CORRECTLY with zero
 GM> margins?
In a word, no. But if you fiddle around with the multi-record mode of
GeoFile (set it to User Level 4) you should be able to come up with a
solution.
Suggested starting point: Take your GeoDraw example and copy and paste
it into a single record while in Design mode. Then switch to
multi-record and it will appear on each label. Adjust page sizes,
margins and individual record sizes to produce the number of labels you
want.
Works for me, but I don't have the same printer and part of the problem
lies in the printer drivers.
Printing on labels is such a vexed question that I hope to have a
detailed article on it shortly in the 'new' GeigaCounteR Magazine.
Subscription details on request.
Regards
Peter Campbell
--- Terminate 4.00
3:633/272.4)
---------------