TS > LS> watts.  A year ago i measured 2925 watts out of it
TS > LS> total very near to clipping, and recently i replaced
TS > With 120 VAC mains at about 40 A?  Other than the fact
 LS> construction types.  This amplifier uses dual 
 LS> complementary rails instead of single complementary 
 LS> rails like chaper amps do.  This makes sustained 
 LS> power output and current output at 25 to 100 percent 
 LS> more than the current draw.  this amplifier used to 
That's done to improve idling and low level operating efficiency certainly, 
especially to decrease cooling demands.  It doesn't decrease power input 
requirements to sustain full output, however.  
 LS> have 1 14 guage line cord.  now with this upgrade it 
 LS> had 2 12 guage line cords with twist lock plugs.  
Other than for industrial vibration analysis (for which amps such as Crown's 
10 KW 3 pahse unit are usually sold), or as part of high level A3 modulators, 
I see little good reason for singular audio amps above the limits of an 
ordinary 120 circuit.  It's usually IMHO better to run more units in 
parallel. 
Terry
--- Maximus 2.01wb
---------------