Hello andrew,

On 07 Jun 15 03:33, andrew clarke wrote to Michiel van der Vlist:

 MV>> No, to write a message in UTF-8, you do not need to use an
 MV>> external editor. What you need is the proper translation table
 MV>> from your local set to UTF-8.

 ac> But my local set is UTF-8.

I had the same issue, and as I told Mark, I just basically created a table 
named utf8_utf8.chs and specified the ID, version, level parameter, then UTF-8 
for the in and out fields and that was it. Obviously it doesn't need any 
translation if you are already using UTF-8 as your local set.

That seemed to fix my issue with the level parameter being 2 instead of 4, at 
least.

Regards,
Nick

--- GoldED+/LNX 1.1.5-b20130910