KG>Charles, thanks for the offer. I do not have internet mail access to
  >send the script to you and the Fido address I think was on the message
  >does not come up in the nodelist.
        What nodelist are you talking about?  Just send a message to me:
              charles.raine@fidonet address
KG>What I am using is the standard MSI script for wildcat boards. What I
  >understand as happening is after so many busy signals (one of the whens
  >in the script for the script to retry) it stops with a "Too Many Whens"
  >error.
        In my manual on page 274, the definition for this error is:
The maximum of 10 WHEN commands were active and an additional WHEN was
issued.  Use a blank WHEN command to clear unused WHEN's and try again.
        Under the definition of the WHEN command, there are 3 types of
when statements.  I have a hunch you may be missing the WHEN (type 3)
which immediately cancels all active WHEN commands.
KG>I wish I could send you the script, but cannot in echo mail. Is the
  >board you use unlisted??
        Unlisted where?  It's Muddy Waters Computer Society, in
Winnipeg, Manitoba, Canada.
Charles Raine           Internet: charles.raine@mwcs.mb.ca
Phone: (204) 895-0940             charles_raine@mbnet.mb.ca
--- QScan/PCB v1.17b / 01-0105
---------------