>>3) Unable to apply Current FixPaks to Warp v4.0 on a 1995mb partition.
>>   The fixpak installs using the latest CSD_141.EXE and QF11 to install from
>    hard drive.  The fix applies and then on re-boot I recieve TRAP ERRORS
>    with very little information in them.
>
>Insufficient info.  What traps with what messages and register dumps. 

     I was unable to get the trap error information, but have re-tried the
process of installing the fixpak again (7th time).  I copied the information
down while I was on another computer/system so that I would be able to save
the
information.  This is what little information it gave me.

trap error on comp-bbs is following:
---------------------------------------------------
TRAP 000d  ERRCD=ff00  ERACC=****  ERLIM=*******
--[ 5 or 6 lines, all entries where  "=********" type entries ]--

system detected an internal processing error at
locatation ##0168:fff492de - 000e:c2de.
60000, 9084

05860525
internal revision 9.035, 99/04/01
----------------------------------------------------
     I have a copy of the TRAP-ERROR code information, but don't know what
needs to be fixed to change the problem.

====================
TRAP 000d
Mike Roark (2:2490/8016)@8213.Fidonet
Thu Oct 02 21:00:37 1997

A trap 000D is caused (but not limited to) when a program references storag
outside the limit of the memory segment, references a storage segment that
restricted to privileged code, references storage with a selector value of
zero, writing read-only memory or code segment, reading from an execute-onl
code segment or loading an invalid value into a selector register. [SYS1943
===================

>Use the ALT-F2 at bootup to see what driver or process was in use when
>Will Honea 

     I tryed the trap dump log file for information.  Nothing in regards to
appling the fixpak was reported.  The file was empty.  Nothing recorded.

     I will try using ALT-F2 on bootup and see what it shows.

     Thanks for the replies.  They have helped.

Glen
The Animal

--- WWIVGate 2.00c