Hello mark!

Nov 16 12:46 03, mark lewis wrote to Bo Simonsen:

 ml>>> i'm starting it all again, right now at the timestamp on this
 ml>>> message... just deleted the maximus directory and unzippes the
 ml>>> max-3.03-etc.tar.gz file and now my script is pulling it all from 
 ml>>> cvs again...

 BS>> Okay. A checkout should do it :-)

 ml> had to do a bit of surgery on sqastr.c and sqaexe.c...

 ml> tr "\015" "\040"  sqastr.c2
 ml> mv sqastr.c sqastr.c1
 ml> mv sqastr.c2 sqastr.c
 ml> tr "\015" "\040"  sqaexe.c2
 ml> mv sqaexe.c sqaexe.c1
 ml> mv sqaexe.c2 sqaexe.c

 ml> then sqastr.c required additional editing to recombine the lines 
 ml> continued by \ on the end of them...

Ahh okay.

 ml> after doing that, i'm am apparently getting a complete compile 
 ml> process as my maxbuild.log file is now ending with..

 ml>   Build Complete; edit your control files and 'make install'

Okay, that's good, you did just remove the \ ?

 ml> i can't tell you what lines contain the ^M in those two source files 
 ml> as i was unable to get grep to look for that character... and i have 
 ml> no idea about the \ continuation lines problem... is there some 
 ml> setting for gcc or something that i may be able to look at and 
 ml> adjust??

I don't have the DOS to Unix program at my hand.. But a tr -d '\r' <
infile > outfile might do it.

Regards,
Bo

--- Msged/LNX 6.1.2 (Linux/2.4.18-586tsc (i586))