RT> WD8013EBT 16-bit edge with 15 way connector and BNC
 RT> Jumpers are for AUI (what is this?) and thin ethernet
Attachment Unit Interface, or something like. The 15 pin connector is for 
attaching the workstation to a thicknet (10base5) backbone.
 RT> with an IRQ jumper tag 3 4 5 7 2/9 10 11 15
 RT> A ROM jumper 16K 32K 64K NONE, an address jumper
 RT> C4000 C8000 D0000 with a ROM size jumper (but no
 RT> ROM chip)
 RT> Well, WfWG detects this as a SMC EtherCard Plus 16 with Boot ROM
 RT> So guess primary info wanted is:  can this card be used with a
 RT> "standard" LAN setup using the 15 way AUI connector (and 'spose a
 RT> termination is required on the BNC)?
There's no reason to use the 15 pin to connect to thinnet since the card also 
has BNC out. To use either the AUI or the BNC to connect that workstation to 
a 10baseT twisted pair LAN requires a  transceiver that costs more then a 
10baseT card does.....
 RT> Incidentally, doing what I thought was an install with this card,
 RT> base memory address D0000 with base I/O port 280 IRQ10, Syschk does
 RT> detect alright at the correct IRQ but MSD not.
MSD won't see the card unless it's hooked to a live network and has it's 
drivers loaded.
--- Maximus 2.02
---------------