RL>You should be able to reverse the wiring on the plug end of the
 
RL>servo if there is no reverse switch on the tx.
 
RL>--- RoboBOARD/FX v6.3
 
 
TIME OUT
If you are trying to reverse servo direction, swaping POS and NEG wires
at the servo plug is a sure way to cook a servo.  That voltage enters a
circut board in the servo and for some unknown reason reversed polarity
is sudden death.  Alas all is not lost...  To reverse the servo, you
have to swap the POS and NEG wires on the servo motor, AND swap the POS
and NEG wires on the feed back pot.
 
Goood Luck, and I hope this isn't too late
 
Larry
***
 þ OLX 2.1 þ It's only a hobby ... only a hobby ... only a
--- TriToss (tm) Professional 1.0 - (Unregistered)
---------------