From | BILL KOPPELMANN
/---------------------------------------
> I've changed my qedit qconfig.dat so that I could use alt s for
> finding information, however, after getting back in to qedit, it
> isn't working. Have any of you any clues as to why that might be?
\---------------------------------------
   To | ALL
Two thoughts:
    - Did you make sure to run QCONFIG.EXE, and chose the keys option to
      make the change take affect in TSE Jr. (formerly QEdit)?  Did you
      make sure that you exited, and then re-started the editor?
   - What did you assign to @S, and is it possible that there is another
     definitions for that key in your QCONFIG.DAT file?
                           George J. De Bruin
                       SemWare Technical Support
------------------------------------------------------------------------------
SemWare Corporation         Phone: (770) 641-9002  FAX: (770) 640-6213
WEB: http://www.semware.com  FTP: ftp.semware.com  
eorge.de.bruin@semware.com
------------------------------------------------------------------------------
 -- SPEED 2.0h #10:
--- FidoPCB v1.4 [ff151/a]
---------------