On Fri, 28 Sep 2018 05:09:09 -0700, jack4747 wrote:

> On Friday, September 28, 2018 at 9:53:19 AM UTC+2, Alister ware wrote:
>> I am trying to configure my printer using the Hplip gui but discovery
>> always fails On my other linux boxes manual specifying the ip address
>> of the printer will suffice to overcome this but it does not seem to
>> work on my Pi3B+
>
> open a browser.
> go to localhost:631 (or IP_of_the_rpi:631 )
> This will open the web interface of the printserver.
> Set your printer from there.
>
> Bye Jack

Which part of "ICups will see & configure the printer ok but I would realy
like to be able
to make use of the HPlip gui as it provides information on ink levels
etc." is causing everyone comprehension difficulties?

I have already configured using CUPS, I want to get the HP Gui working
the same way it does on my other Linux systems (running fedora)



--
Lensmen eat Jedi for breakfast.

--- SoupGate-Win32 v1.05