The following hold commands are ok....

 KK> ; Nodes we put on HOLD
 KK> SEND  hold 1:17/80
 KK> SEND  hold 1:134/10
 KK> SEND  hold 1:134/33
 KK> SEND  hold 1:134/703
 KK> SEND  hold 1:134/503
 KK> SEND  hold 1:134/303
 KK> SEND  hold 1:140/1
 KK> SEND  hold 30:250/140
 KK> SEND  hold 30:1000/0

The following send normal commands are actually NO-OP commands in SQUISH! 
In stead of using "send normal" use "send direct"..

 KK> ; Nodes we DO NOT wish to have routed via LPM
 KK> SEND  normal 1:17/0
 KK> SEND  normal 30:100/all
 KK> SEND  normal 30:1000/all
 KK> SEND  normal NoArc 1:134/77.10
 KK> SEND  normal 1:134/all
 KK> SEND  normal 1:342/1
 KK> SEND  normal 1:134/1 65535/65535 -1/-1

Because the "send normal" commands are no-op's in squish, the
following route normal 1:140/1 will actually send 1:17/0, 1:134/77.10,
1:134/all, 1:342/1 and 1:134/1, 1:65535/65535 and 1:-1/-1 to 1:140/1....

 KK> ; All fall-through mail is now routed through our LPM feed node, 1:140/1
 KK> ROUTE normal 1:140/1 1:all 2:all 3:all 4:all 5:all 6:all
 KK> SEND  normal world

You could enter "change direct normal" commands here if you want
to get the packet flavor back to the standard way instead of leaving them
as direct packets.

Please note that what I am documenting is for SQUISH.  If you were using
the older mail mashers (CONFMAIL, QMAIL, etc.), the SEND NORMAL lines would
have worked as I think you expected them to.

Take care.....

Bob Jones, 1:343/41


--- Maximus/2 3.01