Hello All!
=== Cut ===
Thanks for reading this message. Bascially this is a question that relates
to BPQ over which I run FBB
Basically I am trying to get BPQ to run over a network without much success
and hope someone can assist.
On PC1 which I run the F6FBB.E BBS on I do run BPQ. BPQ is loade by use of
BPQCODE.SYS as the operating system is OS/2. The network cards in use are
PN-10 sries 16 bit Ethernet. My setting on this machine are I/0 240 and IRQ
11...I did previously used thw IN95 on both machine and the network did
function!!
On the other machine I have a different o/s namely Windows95 using
BPQCODE.EXE and the windows switch interface. The I/O is 33 and IRQ 11.
What I want to do is get the software to wrok so that the networking
(NETROM) works between the two machines under BPQ.
I do not know how to confgiure the additional port for this or what other
drivers I have to load. I assume I have yo use ODIDRV but it needs
parameters and I am not sure wher eit goes. Presumably I need to used the
ODI drivers from the manufacturers network installation disk.
Your help would be much appreciated on this.
Thanks....Ron G1MET
=== Cut ===
Regards
        Ron.
                SysOp - OakMoor BBS   ( available 24hrs! )
                FidoNet - 2:250/603
                EMail - oakmoor@warp.co.uk
                EMail - n1yma@crocks.coracle.com
                Packet Radio Address G1MET@GB7FYL.#16.GBR.EU
--- FMailX 1.02
---------------