On 8 Nov 99 06:18pm, Daniela Engert wrote to Sean Dennis:

 DE> Hi Sean!

 DE> Thus quoth Sean Dennis to All :

 SD> I was using SUPRESSPOPUPS=C in my CONFIG.SYS to supress popup error
 SD> messages in my system until I installed FP11 and now I get an
 SD> "invalid statement" error upon bootup concerning that.  Any ideas
 SD> how or why that isn't working anymore?

 DE> It should read 'SUPPRESSPOPUPS=C:'

The correct statement is "SUPPRESSPOPUPS=C", the "C" not being followed
by a colon.  This has not changed with the advent of FP11.

Note that Sean's post above has only one (1) "P" in SUPPRESSPOPUPS when
it should have two (2), making the statement "invalid" as reported by
the system.  Fixing the typo will fix the error.  Adding a colon after
the "C" will, again, make the statement invalid.

George


... At least five buses go by in the opposite direction before yours arrives.
--- Via Silver Xpress V4.4P [Reg]
147/2021